A clogged drain is usually hair, soap scum, or kitchen grease sitting closer to the fixture than you think. You do not need a caustic cleaner to move it, and those bottles often make the next job worse: they sit on top of the blockage, etch finishes, and turn a simple cleanup into a hazardous soup.
This guide covers basin, tub, and shower drains, not a blocked toilet (use a flanged toilet plunger) and not a main sewer line. If more than one fixture is slow at once, or a different room gurgles when you drain the sink, skip to the last sections and call a licensed plumber.
Do not mix drain products. If someone already poured a chemical cleaner into the drain, do not add another cleaner, and do not plunge or open the trap until you know what is in there. Wear gloves and eye protection. Caustic product plus a splash of water is how people end up with chemical burns.
What you are actually clearing
Most household clogs are one of three things:
- Hair and soap in bathroom sinks and showers. Hair catches on the stopper, then soap and skin oils felt it into a plug.
- Grease and food film in kitchen sinks. Fat looks liquid when it is hot, then cools into a sticky lining.
- A foreign object: a cap, a toy, dental floss, or a broken stopper piece.
Chemical cleaners are poor at all three. They may nibble a greasy film, but they will not dissolve a hair knot or retrieve a cap, and they are rough on older metal traps and some plastic fittings.
Work in this order: clear the stopper, plunge with a proper seal, hook the hair you can reach, then open the P-trap if you still need to. Only after that should you consider a small hand auger, and only then a plumber.
Before you start
Lay a towel in the cabinet or along the tub edge. Put a bucket under the trap if you think you will drop it. Put on gloves. If the sink is full of standing water, bail most of it into a bucket so you can see the opening. Leave a few centimetres of water — a plunger needs water to push against.
Remove as much of the stopper hardware as you can. In many bathroom sinks a lift-rod behind the faucet connects to a pivot rod in the tailpiece. With the water off, pop the rod loose (usually a nut and a small clip) and pull the stopper straight up. You will often bring the clog with it. In a tub, the stopper may unscrew, lift out, or hide behind an overflow plate with a couple of screws. In a shower, prise up the hair screen.
If the stopper is packed with hair, clean it in the bucket and test the drain before you go further. A surprising number of "clogged pipes" are clogged stoppers.
Plunge with a seal, not just enthusiasm
A cup plunger (the ordinary sink plunger, not the toilet flange type) works if you can seal the opening and move a column of water. Dry the rim of the cup and, if the porcelain is slightly uneven, a thin smear of petroleum jelly around the lip helps the seal.
Cover any overflow hole with a wet cloth, or have a helper press a cloth firmly over it. On a double kitchen sink, seal the second basket strainer the same way. If air can escape through an overflow or the other bowl, the plunger will just slap.
Seat the cup, push down gently to expel air, then use short, firm strokes — ten to twenty — and lift sharply on the last one. You are trying to shove the blockage one way and then suck it the other, not to hammer the basin. Run water and listen. If it improves but is not clear, plunge again before you reach for a different tool.
A plunger that is still stiff from sitting in a closet works poorly. Soften the cup under warm water for a minute so it can flop into a seal.
Hook the hair you can reach
If plunging is not enough, a cheap plastic hair hook (sometimes sold as a "zip" style strip) or a small drum auger will often catch the rest. Feed it slowly into the drain and do not force a sharp bend. Twist as you go, then pull back in short tugs. You may need several passes. Wipe the gunk into a bag, not back into the sink.
Do not ram a wire coat hanger down the pipe. You can scratch a chrome tailpiece, punch a hole in a plastic trap, or shove the clog into a tighter bend.
For a shower or tub, a 7-metre (25-foot) consumer drum auger is usually long enough to reach past the trap. Crank slowly. If the cable binds hard and you cannot withdraw it, stop. A licensed plumber with the right cable is cheaper than a broken pipe inside the floor.
Open the P-trap
The P-trap is the U-shaped bend under a sink. It holds a little water to block sewer gas, and it also holds a lot of clogs. Place the bucket underneath. If the slip nuts are metal and old, wrap them with a cloth and use adjustable pliers so you do not chew the corners; many newer traps are plastic and can be loosened by hand.
Loosen both nuts, ease the trap down, and empty it into the bucket. Check the trap itself and the short horizontal arm that runs into the wall. A flashlight helps. You can pull out debris with a gloved finger or a short brush. Rinse the trap in the bucket, inspect the washers, and put it back just snug — overtightening cracks plastic nuts and can warp the seal.
Run water and watch the joints from below before you close the cabinet. A slow drip now is easier than a swollen cabinet floor next week. If a washer is crushed or missing, replace it; they are inexpensive and sold in mixed packs at any hardware store.
Kitchen grease is a habit, not only a clog
If you have just cleared a kitchen sink, change the habit or you will be back under the cabinet in a few months. Wipe greasy pans with a paper towel before they go in the sink. Coffee grounds and starchy leftovers belong in the bin, not the drain. Very hot water does not "melt grease down the city line"; it often moves the fat a short distance so it can harden in a cooler pipe.
A strainer and a monthly flush of hot (not boiling) tap water is enough for most houses. Boiling water is hard on some PVC fittings, so skip the kettle.
What about baking soda and vinegar?
The familiar sink volcano is a mild acid-base reaction. It can loosen a light soap film, but it is not a mechanical clog tool. If you enjoy the ritual, use a modest amount, wait, and rinse with hot tap water. Do not treat it as a substitute for hooking hair or opening a trap, and do not follow it with a commercial chemical cleaner.
Enzyme "maintenance" products try to nibble organic film over time. They will not open a standing blockage today. If you use one, follow the label and keep it away from leftover caustic cleaner.
When the clog is not at this fixture
Stop DIY and call a licensed plumber if:
- Two or more fixtures are slow or overflowing at once.
- You hear gurgling in a tub or floor drain when the washing machine or a nearby sink empties.
- Water is coming up at a basement floor drain.
- You have already opened the trap and the blockage is clearly in the pipe inside the wall or floor, and a short consumer auger will not reach it.
- There is sewage odour you cannot explain, or sewage backing up.
Those are signs of a branch or main line problem. In older Canadian houses that line may be original cast iron or, in some neighbourhoods, a clay sewer that roots have found. Pushing harder from a bathroom sink will not fix it.
If a tub is slow and the room also stays damp after showers, see how to remove mould from shower grout — but do not ignore a true plumbing backup.
After it flows again
Replace the stopper, confirm that the pivot rod still opens and closes, and put a hair catcher on showers and tubs. Clean it weekly. That dull habit prevents most of the jobs in this guide.
If the faucet itself is dripping into the basin, fix that next. A drip does not cause a clog, but it wastes water and it is usually a short repair: how to fix a leaky faucet.